Comtech EF Data CDM-500 - Manual (Page 84)

Rev. 1.3 i–1
I
Index
- A -
Address................................................... B–4
Alarms Connector .................................. 5–2
Approvals ............................................... A–3
Auxiliary Serial Connector .................... 5–3
- B -
Basic Protocol ........................................ B–2
Buffer Disabled ...................................... 7–2
Buffer Enabled, Rx<>Tx........................ 7–2
Buffer Enabled, Rx=Tx.......................... 7–2
- C -
CONFIG) FRAME (Framing Mode) ..... 6–12
CONFIG) IMPED (IF impedance) ......... 6–18
CONFIG) INTFC (Interface) ................. 6–14
CONFIG) MASK (Alarm mask) ........... 6–16
CONFIG) REMCONT (Remote control)6–14
CONFIG) RX (Receive)........................ 6–8
CONFIG) TX (Transmit) ...................... 6–5
CONFIG, FRAME) FRAMED .............. 6–12
CONFIG, FRAME) TRANSPARENT .. 6–12
CONFIG, MASK) AGC........................ 6–16
CONFIG, MASK) BUF-SLIP ................ 6–17
CONFIG, MASK) Eb/No....................... 6–17
CONFIG, MASK) RX-AIS .................... 6–17
CONFIG, MASK) TX-AIS .................... 6–18
CONFIG, RX) ACQ.............................. 6–10
CONFIG, RX) DATA (Data Rate) ....... 6–9
CONFIG, RX) DESCRAM................... 6–10
CONFIG, RX) FEC............................... 6–9
CONFIG, RX) FRQ (Frequency)...........6–9
CONFIG, RX) MOD (Modulation) .......6–8
CONFIG, RX) BUF (Buffer size)...........6–11
CONFIG, RX) CLK (Clocking)..............6–10
CONFIG, RX) Eb/No (Eb/No Alarm) ....6–12
CONFIG, RX) RSI .................................6–11
CONFIG, TX) CLK (Clocking).............6–7
CONFIG, TX) DATA (Data Rate) ........6–5
CONFIG, TX) FEC................................6–6
CONFIG, TX) FREQ (Frequency) ........6–5
CONFIG, TX) MOD (Modulation) .......6–5
CONFIG, TX) ON/OFF.........................6–6
CONFIG, TX) PWR (Power) ................6–7
CONFIG, TX) SCRAM (Scrambling) ...6–7
CONFIG, TX) TSI .................................6–8
CONFIG:.................................................6–4
Configuration ..........................................2–2
Connect External Cables.........................2–2
Connector Pinouts...................................5–1
- D -
Data Connector .......................................5–1
Data Interfaces ........................................A–3
Demodulator ...........................................A–2
Description..............................................6–1
Disclaimer ...............................................viii
- E -
EIA-232...................................................B–2
EIA-485...................................................B–1
Electrical Safety......................................vi
EMC (Electromagnetic Compatibility)...vii