Comtech EF Data SMS-451 - Manual (Page 27)

2-1
Chapter 2. INSTALLATION
This chapter provides system installation and external connection information.
2.1 Unpacking
The switch and manual are packaged in pre-formed reusable foam inside a cardboard
carton.
To remove the switch:
CAUTION
Do not use any cutting tool that will extend more than 1 inch into the
container and cause damage to the switch.
1. Cut the tape at the top of the carton where it is indicated OPEN THIS END.
2. Lift off the foam covering the switch.
3. Remove the switch, manual, and power cords from carton.
4. Save the packing material for reshipment either back to the factory or to another
site.
5. Inspect the equipment for damage incurred during shipment.
6. Check the equipment against the packing list shipped with the equipment to
ensure that the shipment is complete.
7. Refer to Section 2.2 system installation instructions.