Comtech EF Data Ku-Band Power Amplifier with Optional L-Band - Manual (Page 21)

Outdoor Power Amplifier Revision 0
Mounting MN/ODPA.OM
2–3
2.2.2 Mounting Instructions
PRODELIN 1.8, 2.4, and 3.8 M: Channel Master 2.4 and 3.8 M.
1. Position the two 20” Unistrut channels on the backside of the BUC box, aligning
and centering the two center slots of the channel with the mounting holes of the
BUC. Fasten with the 1/4” hardware (4 each bolts, split and flat washers).
2. Position the BUCs and mounting brackets facing upward, leaving a gap between
roughly the width of the BUC. Ensure that all items are oriented correctly and
fasten with the 1/4” hardware (twelve each bolts, split and flat washers).
Note: It may be necessary to loosen the hardware on the BUC in order to align
the mounting holes between the Unistrut channels and the converter brackets.
3. (For SPAR Mount Kit PL/7725-1 only) Using a Spar support bracket as a guide,
position two spring nuts in each of the Unistrut channels. The threaded holes in
the spring nuts must be aligned with the holes in the Spar support brackets and
should be centered in the Unistrut channels.
4. (For Spar Mount Kit PL/7725-1 only) Position the assembly on the Spar arm of
the antenna and fasten the Spar support brackets to the spring nuts in the
Unistrut with the 5/16” hardware (4 each bolt, split and flat washer).
5. Ensure that the assembly is mounted in such a manner as to provide enough
room for cabling and to avoid interference to surrounding objects.