About this manual, Safety notices, Lithium battery replacement – Comtech EF Data Ku-Band Power Amplifier with Optional L-Band User Manual
Page 11: Metric conversion, Trademarks

Outdoor Power Amplifier
Revision 0
Preface
MN/ODPA.OM
v
About this Manual
This manual provides installation and operation information for the Comtech EF Data
Ku-Band Power Amplifier with Optional L-Band, herein after referred as the Outdoor
Power Amplifier (ODPA). This is a technical document intended for earth station
engineers, technicians, and operators responsible for the operation and maintenance of
the ODPA.
Safety Notices
This equipment has been designed to minimize exposure of personnel to hazards. The
operators and technicians must:
•
Know how to work around, with, and on high voltage and high RF power
level equipment.
•
Exercise every precaution to ensure personnel safety.
•
Exercise extreme care when working near high voltages/high RF power
level equipment.
•
Be familiar with the warning presented in this manual.
WARNING
•
Disconnect the power supply cord before servicing the SSPA.
Lithium Battery Replacement
WARNING
There is a possibility that the Lithium battery on the M&C assembly will
explode if the battery is incorrectly replaced. Observe all instructions from
the battery manufacturer. Replace only with the same or equivalent type
battery recommended by the manufacturer. Dispose of used batteries
according to the Lithium battery manufacturer’s instructions.
Metric Conversion
Metric conversion information is located on the inside back cover of this manual. This
information is provided to assist the operator in cross-referencing English to Metric
conversions.
Trademarks
Windows is a trademark of the Microsoft Corporation.
Other product names mentioned in this manual may be trademarks or registered
trademarks of their respective companies and are hereby acknowledged.