6 fx series installation pattern (routed), Fx series installation pattern (routed) – Comtech EF Data FX Series Quick Start Guide User Manual
Page 4
4
FX Series Quick Start Guide
Section: FX Series Installation Pattern (Routed)
1.6 FX Series Installation Pattern (Routed)
1.6.1 Cable the Appliance
Connect the eth3 (WAN) port to a switch or a router.
1.6.2 Configure the Appliance
Login to the appliance through the browser interface at:
http://{IP_address_of_the_appliance}:10000
1. Enter the default user name “comtech” and the
default password “comtech”.
a. Click Login.
2. Click Configuration -> General Settings
a. Change “Traffic interception mode” to
“Routed”
b. Click Save
3. Click In-Path Interfaces
a. Click the Add button to add a new in
interface.
•
Enter the VLAN ID of 0
tagged. Use the VLAN ID of the VLAN if
traffic is to be VLAN tagged.
•
Enter the IP Address.
•
Enter the Netmask
•
Enter the Gateway
•
Enter any static routes needed in the
“Routes” field.
b. Click “Add In-Path Interface”
c. Click the “Return to Configuration” link
4. Click on LAN Interfaces.
a. Click on the “Add” button to add a new LAN
interface.
•
Select “eth3” in the “Physical interface”
selection box.
•
In the “In-Path Interface(s)” selection box,
click the IP address of the in
interface *see above*.
•
In the “Untagged in
selection box, select the IP address of the
in-path interface *see above*.
“none” if the VLAN tag is to be
propagated across the WAN.
b. Click “Add LAN Interface”.
c. Click the “FX Series Administration Index” link
at the top of the page.
5. Click “Status”, then click “Real
FX Series Quick Start Guide – Installation Patterns
Guide - Version 6.0 Rev 1
FX Series Installation Pattern (Routed)
MN
For More information
http://www.comtechefdata.com/stampedeDocs.asp
FX Series Installation Pattern (Routed)
Connect the eth3 (WAN) port to a switch or a router.
Login to the appliance through the browser interface at:
http://{IP_address_of_the_appliance}:10000
Enter the default user name “comtech” and the
default password “comtech”.
> General Settings
ic interception mode” to
Click the Add button to add a new in-path
Enter the VLAN ID of 0, if no VLAN is to be
tagged. Use the VLAN ID of the VLAN if
traffic is to be VLAN tagged.
Enter the IP Address.
Enter the Netmask
Enter the Gateway
Enter any static routes needed in the
“Routes” field.
Path Interface”
Click the “Return to Configuration” link
Click on the “Add” button to add a new LAN
Select “eth3” in the “Physical interface”
selection box.
Path Interface(s)” selection box,
click the IP address of the in-path
interface *see above*.
In the “Untagged in-path interface”
selection box, select the IP address of the
ath interface *see above*. Select
“none” if the VLAN tag is to be
propagated across the WAN.
Click “Add LAN Interface”.
Click the “FX Series Administration Index” link
at the top of the page.
Click “Status”, then click “Real-Time Monitor”, then click “Restart Service”.
Installation Patterns
MN-FXADMIN6-QSG Rev 1
For More information Tel: 1-937-291-5035
http://www.comtechefdata.com/stampedeDocs.asp