CompX eLock Temperature Monitoring Programming - Manual (Page 7)

Temperature Monitoring
sample
2d bar code. Provides the same information as sticker
number three, but a 2d laser scanner is needed to
decode the information.
1d bar code. Place this sticker on or around the CompX
eLock® unit to help identify which codes to use if
resetting the lock is necessary.
Keep this sticker in a safe location.
Serial #: Needed to identify CompX eLock® units
Passcode: Unique to lock. Needed for LockView.
Prevents unauthorized LockView use
User Rst: Allows administrator or owner to erase
all user codes from eLock unit but keep
supervisor codes
Fact Rst: Erases all codes from eLock, including
settings. eLock unit will need to be set
up again after a Factory Reset (see page 2)
7
Sticker #1
Sticker #2
Sticker #3
These stickers are included with each CompX eLock® unit. Please review the information and keep the stickers in a safe
location as they may be needed to reset or identify a specific eLock unit. The codes shown here are not real codes. They
are representations of what the stickers will look like.
NoTe:
Don't forget
to fill out and
return your
warraNTy
card!
sample
sample
sample
(SAMPLE) CompX eLock® Registration card
Company Phone# ( ) -
Address
Authorized Contact
Position
Serial #
Pass Code
User Reset Code
Factory Reset Code
Sticker #3
sample
Affix one copy of sticker #3 to
the CompX eLock® registration
card and return to CompX Fort
at address shown on the other
side of the registration card.