Compuprint 6314 CZL - Manual (Page 11)

CZL – Programmer Manual
11
3.1.2 Field definition
These commands make it possible to define the type and position of the fields (e.g. alphanumeric
strings) that comprise the label.
^FOx,y (Field Origin)
This command determines the position of the upper left corner of the field in relation to the zero
coordinate set by the command ^LH (page 8) and is independent of the rotation. In other words,
whatever the rotation, the upper left corner of the rectangle surrounding the field is set to the
coordinate x, y (see fig. 3). When the field is horizontal (whether its rotation is normal or inverted),
it is always in the same position as when it is vertical (whether its rotation is rotated or bottom up).
fig. 3 – Rotation of a field positioned with the ^FO command
x is a whole number from 0 15 to 9999 16 and is the horizontal position along the x axis (see fig. 2 on
page 9) in the upper left corner of the field, expressed in dots 17 .
y is a whole number from 0 18 to 9999 19 and is the vertical position along the y axis in the upper left
corner of the field, expressed in dots.
^FTx,y (Field Typeset)
This command, like the previous one, sets the position of the origin of the field (in relation to the
zero coordinate set by the ^LH command described on page 8) consistently with the content of the
15 Default value.
16 See note 4 on page 9.
17
See note 5 on page 9.
18
Default value.
19
See note 7 on page 9.