Code Blue IA4100 SINGLE BUTTON ANALOG SPEAKERPHONE - Manual (Page 8)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-139-J page 8 of 29
IA4100
Administrator Guide
PRE-INSTALLATION
1.0 Electrical preparation – The unit may have supply wires run from either (a) behind the unit
through the wall, or (b) below the unit by using an external conduit through the bottom of the unit’s
back plate. Mounting holes in the back, bottom or side of unit to be administered by the installer.
IMPORTANT: If wiring is coming in from the bottom or back, insure that the conduit is
aligned at this time. Connect electrical and communications wiring (see wiring instructions). Follow
all national and local codes that apply.
1.1 Prepare Wall – FME enclosure mounting hole in wall should except the housing dimensions
below and must be smaller than the faceplate dimensions to ensure clean flush mount look.
INSTALLATION PROCEDURES
1.2 Mark the flush mount mounting hole – In order to comply with the Americans with Disabil-
ities Act (ADA) of 1990, the speakerphone button(s) should be positioned between 34 and 48 inches
from grade level. (Consult an ADA specialist in your area to verify local and federal guidelines.)
1.3 Secure the housing to the wall – The Flush mount enclosure can be mounted from the
back, bottom or side by drilling the mounting holes where needed per the installers application while
still keeping the unit within ADA compliance height. (1.2) Mounting hardware to be supplied by in-
staller.
6 Optional Flush Mount Enclosure Installation Instructions