Code Blue IA4100 SINGLE BUTTON ANALOG SPEAKERPHONE - Manual (Page 14)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-139-J page 14 of 29
IA4100
Administrator Guide
12 Advanced Programming
Information programmed into the phone is represented by .
When the instructions call for entering 1#, simply press 1 and the default
password, followed by the # (pound) symbol on your telephone keypad. For example, the default
password on the IA4100 is 2583. To put the IA4100 into Program Mode, dial 12583#.
When you enter a command (CMD) correctly, the unit will respond with a single beep (DTMF “B”).
If a command has been entered incorrectly, the unit will respond with a rejection triple beep (DTMF
“BBB”). When commands are met with a triple beep, the command has not been accepted and will
not affect the programming of the unit.
All necessary commands can be entered during one programming session. Any time the unit re-
sponds (with either a single beep or a rejection triple beep), it is capable of accepting another com-
mand.
When you first dial into the IA4100 speakerphone you will hear a Request For Acknowledgment
(RFA) tone. If a response from you is not received within seven (7) seconds the IA4100 will remain
in two-way audio mode and accept In Call Commands (section 5.2). Because the unit has not yet
been programmed, you should dial 12583# on your touch-tone keypad to enter Program Mode.
The unit can be forced to hang up by depressing the
Ý
(star) followed by the # (pound) symbols on
the telephone keypad. If the
Ý
# sequence is not used to hang up the IA4100, the phone is pro-
grammed to recognize a Disconnect Supervision such as a WINK or reverse polarity signal from the
PBX or PSTN. Also available is a Silent Time Out (CMD 42), reorder tones or revert to dial tone. The
speakerphone will hang up once it has received any of these standard end of call signals. If none of
those Supervised Disconnects occur, the speakerphone will stay active (i.e., Call received LED light
stays on) after the called party has hung up or until the Call Timer expires.
NOTE: You MUST program the speakerphone after installing the Code Blue unit.