Code Blue IA4100 SINGLE BUTTON ANALOG SPEAKERPHONE - Manual (Page 15)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-139-J page 15 of 29
IA4100
Administrator Guide
12.1 Initial In-Call Commands
The following commands are used after the RFA (Request For Acknowledgement) tone upon initial
call in. When calling the extension or phone number of the IA4100 you will hear the RFA tone
(DTMF “B”). If a new command mode is not selected within seven seconds, the IA4100 will default
to two-way call mode (full monitoring) and will start accepting “Commands During A Call” (see
page 8).
Initial Call-In Modes
Command Explanation Format Default
1 Programming Mode 1 # 1 2583#
3 Full Monitoring, two-way
(microphone and speaker)
3 # 3#
4 Silent Monitoring, one-way call
(speaker is off)
4 # 4#
5 Monitoring, one-way call
(microphone is off)
5 # 5#
8 UPD Fault Reporting Mode 1 8#
9 Paging Mode 2 9#
Ý
# Forced Hang Up
Ý
#
NOTES: 1 UPD Fault Reporting Mode allows the UPD software to check the system for faults.
2 Paging Mode is utilized to send the incoming call output to the attached Public Address
System (PAS) amplifier/speaker array.