Cloud Electronics CDR-1B - Manual (Page 16)

CDR‑1 & CDR‑1F Installation Guide v2.0 16
Installer mode allows access to the following unit-specific settings:
•
Backlight and contrast adjustment
•
Inactivity time
•
Zone assignment
•
Set Engineer key
Each of the above settings can be accessed in turn by pressing the ZONE button.
A full description of Installer Mode can be found in the
DCM-1/e Installation and
User Guide, Section 3 (Configuration).
To return the CDR to normal operation:
•
Remove power from the CDR.
•
Move jumper J1 from ON to OFF
•
Reapply the power
•
Refit the remote control to its mounting plate with the two M3 screws (CDR-1)
or to its back box/mounting hole with the front panel fixing screws (CDR-1F).
User mode
The CDR’s normal operating state is User Mode, which permits selection of music
source, level adjustment, and Group enabling/disabling (if available).
User Mode is fully described in the DCM-1/e Installation and User Guide,
Section 3 ( Configuration).
Engineer mode
The CDR can be used to adjust the EQ in a zone from within the zone itself by putting
it in Engineer Mode. Engineer Mode must first be enabled from the DCM-1/e, and then
a “password” key code entered on the CDR. The default key is listed below. The key can
be changed in Installer Mode.
A full description of Engineer Mode, and how to enable it can be found in the
DCM-1/e Installation and User Guide, Section 3 (Configuration).