Delphi VITALPOINT II DL-00035 User Manual
Page 29
DL-00035 Rev. 4
15
Measuring Pulse Oximetry
The monitor will display the following instructions to apply the pulse oximetry
sensor and take a pulse oximetry measurement:
1. Place the finger sensor on your middle or index finger. If the blood pressure
cuff is also in use, do not apply the finger sensor and blood pressure cuff to
the same arm.
2. Fit the sensor as shown on the screen.
When ready, press “Take Measurement” and remain still until the measurement
is complete. When finished, the measurement will be displayed on the screen.
If you receive any error codes while taking measurements, follow the instructions
on the screen and contact your clinician.
Measuring Temperature
The monitor will display the following instructions to use the temperature probe
and take a temperature reading:
1. Put the tip into a new disposable plastic cover, if one is available.
If you do not have a plastic cover, clean the pointed end (probe)
with soap and warm water or rubbing alcohol. Rinse it with cool water.
2. With your mouth open, put the covered tip under your tongue.
3. Close your lips gently around the temperature probe.
When ready, press “Take Measurement” and remain still until the measurement
is complete. When finished, the measurement will be displayed on the screen.
If you receive any error codes while taking measurements, follow the instructions
on the screen and contact your clinician.