Caple C770 - Manual (Page 4)

Page 4
C770 user manual.DOC
FOR THE USER
IT IS NECESSARY THAT ALL THE OPERATIONS REGARDING THE INSTALLATION,
ADJUSTMENT AND ADAPTATION TO THE TYPE OF GAS AVAILABLE ARE CARRIED
OUT BY QUALIFIED PERSONNEL, IN CONFORMITY WITH THE REGULATIONS IN
FORCE.
THE SPECIFIC INSTRUCTIONS ARE DESCRIBED IN THE BOOKLET SECTION
INTENDED FOR THE INSTALLER
USING THE BURNERS
The symbols silk-screen printed on the side of the knob indicate the correspondence
between the knob and the burner.
Automatic start-up without valves
Turn the corresponding knob anticlockwise up to the maximum position (large flame, fig. 1)
and press the knob.
Automatic start-up with valves
Turn the corresponding knob anticlockwise up to the maximum position (large flame, fig.1)
and press the knob. Once the burner has been started up, keep the knob pressed for about
10 seconds.
Using the burners
In order to obtain the maximum yield without waste of gas, it is important that the diameter
of the pot is suitable for the burner potential (see the following table), so as to avoid that
the flame goes out of the pot bottom (fig.2).
Use the maximum capacity to quickly make the liquids reach the boiling temperature, and
the reduced capacity to heat food or maintain boiling. All of the operating positions must be
chosen between the maximum and the minimum ones, never between the minimum
position and the closing point.
The gas supply can be interrupted by turning the knob clockwise up to the closing position.
If there is no power supply, it is possible to light the burners with matches, setting the knob
to the startup point (large flame).
Burners Power W Dia. Of Pans
Auxiliary 1000 10-14 cm
Semi-rapid 1650 16-18 cm
Rapid 3000 20-22 cm
Ultra-rapid 3300 24-26 cm