Caple CR9201AN - Manual (Page 6)

6
Fig. 2.1
2 - Location
FOR THE INSTALLER
650 mm
500 mm
450 mm
50 mm
This cookers has class “2/1” overheating protection so that it can be installed next
to a cabinet.
The furniture walls adjacent to the cooker must be made of material resistant to heat.
The veneered synthetical material and the glue used must be resistant to a temperature
of 90°C in order to avoid ungluing or deformations.
If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop,
a gap of at least 50 mm must be left between the side of the cooker and the furniture.
The cooker may be located in a kitchen, a kitchen/diner or bed-sitting room but not in
a room containing a bath or shower.
Curtains must not be fitted immediately behind appliance or within 500 mm of the sides.
It is essential that the cooker is positioned as stated below.
If the cooker is located on a pedestal it is necessary to provide safety measures to
prevent falling out.
The cooker must be installed by a qualified technician and in compliance with
local safety standards.