Caple CR9201AN - Manual (Page 34)

34
Gas tap
If a tap becomes stiff, do not force; contact your local Service Centre.
Flexible tube
From time to time, check the flexible tube connecting the gas supply to the cooker.
It must be always in perfect condition; in case of damage arrange for it to be replaced
by a C.O.R.G.I. registered installer.
Cleaning
All the enamelled parts must be cleaned with a sponge and soapy water or other non-
abrasive products.
Dry preferably with a soft cloth.
Acidic substances like lemon juice, tomato sauce, vinegar etc. can damage the enamel
if left too long.
Stainless steel models only:
- Stainless steel surfaces (coated)
The stainless steel front panels on this cooker (facia, oven door and storage
compartment) are protected by a finger-print proof lacquer.
To avoid damaging this lacquer, do not clean the stainless steel with abrasive cleaners
or abrasive cloths or scouring pads.
ONLY SOAP/WARM WATER MUST BE USED TO CLEAN THE STAINLESS STEEL
SURFACES.
- Stainless steel surfaces (uncoated)
The hob + sides are made from un-coated stainless steel and can be cleaned with
an appropriate stainless steel cleaner.
Replacing the oven light bulb
Switch the cooker off at the mains.
When the oven is cool unscrew and replace the bulb with another one resistant to high
temperatures (300°C), voltage 230 V (50 Hz), 15 W, E14.
Note: Oven bulb replacement is not covered by your guarantee.
Stainless steel models only or models with stainless steel
hob: