Caple CR9201AN - Manual (Page 38)

38
Assembly and dismantling
of the side runner frames
– Fit the side runner frames into the
holes on the side walls inside the
oven (Fig. 8.8).
– Slide the tray and rack into the run-
ners (Fig. 8.9).
– The rack must be fitted so that the
safety catch, which stops it sliding
out, faces the inside of the oven.
– To dismantle, operate in reverse
order.
Fig. 8.8
Fig. 8.9
Inside of oven
This must be cleaned regularly.
Remove and refit the side runner frames
as described on the chapter “Assembly
and dismantling of the side runner
frames”.
Side runner frames, tray and rack can
be removed and washed.
The oven should always be cleaned
after use when it has cooled down.
The cavity should be cleaned using a
mild detergent solution and warm water.
Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations
and testing a small sample of the oven
cavity. Abrasive cleaning agents or
scouring pads/cloths should not be
used on the cavity surface.
NOTE: The manufacturers of this
appliance will accept no responsibility
for damage caused by chemical or
abrasive cleaning.
Let the oven cool down and pay
special attention no to touch the hot
heating elements inside the oven
cavity.