D-Link WIRELES 108 ROUTER DI-724GU User Manual
Page 31
31
D-Link DI-724GU User Manual
Section 3 - Configuration
You can either type in an alternate MAC address (for example, the MAC address of the router initially connected to the
ISP) or copy the MAC address of a PC. To copy the MAC address of the computer that initially connected to the ISP,
connect to the router using that computer and click the
Clone Your PC’s MAC Address button. The WAN port will then
use the MAC address of the network adapter in your computer.
The IP address of the Domain Name Server. Your ISP will provide this information if it is required; otherwise, leave this
box set to 0.0.0.0.
The IP address of the Domain Name Server. Your ISP will provide this information if it is required; otherwise, leave this
box set to 0.0.0.0.
When the the router detects that the WAN cable has been disconnected, it waits for “Link Drop Delay” seconds before
treating the WAN connection as broken. This delay allows you to temporarily remove the WAN cable without dropping
the logical connection to the ISP. It also allows for temporary electrical “glitches” in the physical connection. Values can
range from 0 to 65535 seconds. A value of zero causes immediate disconnection when the cable is pulled or when a
glitch occurs. Having to increase Link Drop Delay because you are experiencing WAN disconnections for long periods
would suggest a fault with the cable or with the modem (if any) to which it is connected.
If this box is left blank, the router selects the usual MTU settings for the type of WAN interface in use. The Maximum
Transmission Unit (MTU) is a parameter that determines the largest packet size (in bytes) that the router will send to the
WAN. If LAN devices send larger packets, the router will break them into smaller packets. Ideally, you should set this to
match the MTU of the connection to your ISP. Typical values are 1500 bytes for an Ethernet connection and 1492 bytes
for a PPPoE connection. If the router’s MTU is set too high, packets will be fragmented downstream. If the router’s MTU
is set too low, the router will fragment packets unnecessarily and in extreme cases may be unable to establish some
connections. In either case, network performance can suffer.
MAC Address
(continued):
Primary DNS
Address:
Secondary DNS
Address:
Link Drop Delay:
MTU: