BUG-O Systems UNI-BUG III User Manual
Page 9
9
CONTROLS, CONT’D.
LCD DISPLAY:
Displays the programming parameters such as travel speed, skip
length, crater fill, and weld length.
TRAVEL SPEED:
Used to adjust the travel speed of the machine.
INCREASE BUTTON: Increases the numerical value of the selected parameter.
DECREASE BUTTON:
Decreases the numerical value of the selected parameter.
ENTER BUTTON:
Enters the set value into memory and toggles you to the next parameter.
SKIP LENGTH:
When selected enter the value of the length of the skip distance.
CRATER FILL:
When selected enter the value of the crater fill time.
WELD LENGTH:
When selected enter the value of the length of the weld.
TRAVEL DIRECTION: Dictates which direction the machine will travel. Must be in the “OFF”
position to program parameters.
SKIP / CONTINUOUS: Used to select either the skip or continuous welding operation.
CIRCUIT BREAKER: Provides overload protection for the machine.
POWER ON / OFF:
Turns power on and off to the machine.
WELD CONTACT I:
If using one welding gun, switch weld contact 1 to the “ON” position.
WELD CONTACT II: If using two welding guns, both weld contact 1 and 2 should be switched
to the “ON” position.