BUG-O Systems SE-2PTD - Manual (Page 18)

18
AUXILIARY MODES / Type 6, Quadrant 3
Auxiliary Modes are additional controls to independently turn the two internal solid-state relay
outputs “ON and OFF”, and to switch the machine into rapid traverse mode or set speed.
The machine is shipped with OUTPUT (1) wired to the external relay or solenoid connector. By
default, this output turns “ON” when the START / RESUME button is pressed to run a shape,
and turns “OFF” at the end. The output is taken from screws (3) and (4) on the 4-terminal strip
on the controller inside the machine.
ONLY OUTPUT (1) IS NORMALLY USED.
OUTPUT (2) is present at screws (1) and (2) on the controller, but not wired. By default the
output is “OFF” when a shape is started, until turned “ON” by command TYPE 5, QUADRANT 1.
Both the Plasma Kit and the Oxy-fuel Kit use only output (1). Subsequently while running, the
TYPE 5 “ON” and “OFF” commands turn both outputs “ON” and “OFF” together, and both then
“OFF” at the end.
When programming TYPE 6 QUADRANT 3, a mode number is required to be entered. The
eight auxiliary modes, numbered 0 through 7, allow the setting of a mode with any combination
of outputs “ON” or “OFF” and choice of set speed by the speed knob or maximum speed
regardless of the setting. The combinations are listed in the table below:
MODE CHART
MODE NO. OUTPUT 1 OUTPUT 2 SPEED
0 OFF OFF SET
1 OFF ON SET
2 OFF OFF HI
3 OFF ON HI
4 ON OFF SET
5 ON ON SET
6 ON OFF HI
7 ON ON HI
SET PERCENT SPEED Type 6, Quadrant 4
Selecting TYPE 6, QUADRANT 4 allows the speed to change to a fraction of the set speed. The
display will read “Speed %”, and data entry is accepted from 1 to 99. Entering 0 or return will
make the speed 100%, which is the same as the set speed.
When the program reaches a TYPE 6, QUADRANT 4, segment while running, the speed
will change to the percent entered, and continue at this setting until there is a later TYPE 6,
QUADRANT 4, segment which changes it to another % setting or back to 100%.
NOTE: If TYPE 6, QUADRANT 4, has been set for HI (rapid traverse), then this setting will cut
down the HI speed to the same %. Settings below 10% are not recommended.