BUG-O Systems SE-2PTD - Manual (Page 11)

11
SWITCHING PROGRAMMING MODES
The machine runs in either the SHAPE PROGRAM, for custom programmed shapes, or the
PIPE PROGRAM, for common pipe intersections
To switch functions:
1. Press “C” on the pendant keypad
2. Release the key immediately
3. Press “F” immediately (within half a second)
The machine should change to the other program:
EXAMPLE: If the machine was in the PIPE PROGRAM, the Message “SHAPE PROG”
will now be displayed on the pendant display. If the machine was in the SHAPE
PROGRAM, the message “PIPE PROG” will now be displayed in the pendant display.
SAVING PROGRAMS
The machine has 10 storage areas numbered cut 0 to 9 in memory, either PIPE PROGRAMS
or SHAPE PROGRAMS can be saved in memory. To switch to a different cut number, Push
“C” on the pendant keypad and enter the desired number. Program data is retained until
reprogrammed. At any time, one of these numbers are selected, it will stay selected even when
power is shut off and turned back on, it will not change until the program number is changed by
the operator.
PROGRAMMING, DATA ENTRY
When entering data with the pendant keypad, multiply inches, degrees, or seconds by 100 and
enter the number without a decimal point. For metric dimensions, multiply mm X 10 or cm X
100.
Example: 350 for 3.5 inches,
800 for 80 mm, on metric machines
1500 for 15 degrees
Press the return button after the number is entered.