BUG-O Systems SE-4PTD - Manual (Page 24)

24
TECHNICAL DATA
Power SEO-4400 120 VAC / 50-60 Hz /1.0 A
Requirements SEO-4402 240 VAC / 50-60 Hz /0.7 A
Cutting Diameter Pass through 8'' to 12.5” O.D. (200 to (315 mm)
or 4 to 8'' (100 to 200 mm) with optional extension jaws. Smaller
diameters can be handled at lower cutting speeds – see chart
below.
Additional Short lengths of pipe up to 20'' (508 mm) diameter can be chucked
Capacity: internally.
Maximum Length: 18'' (457 mm)
Maximum Weight: 150 lbs (68 kg)*
Rotation Speed 0.15 to 3.0 rpm
(See charts for surface speed at various diameters)
*NOTE: When using the pass through feature, the maximum weight of the pipe should not exceed
500 lbs (227 kg). it is very important to have the pipe supports in alignment with the machine to
support the pipe in back of the SE-4PTD. If the pipe is projecting from either end of the machine,
more than 30'' (760 mm), it must be supported in rotating pipe stands.