BUG-O Systems SE-4PTD - Manual (Page 10)

10
PROGRAMMING
For programming, the following keys on the keypad are used:
Push A: To select the time delay for plasma cutting.
B: To enter the time delay for plasma cutting.
C. To display the Cut No. in memory (Nos. 0-99)
D. To display the type and dimensions of cut.
E. To enter end of cut slowdown.
To Program a cut, select one of five types as follows:
Type 1: Saddle Cut on centerline.
Type 2: Saddle Cut offset (hillside).
Type 3. Lateral Cut, offset or on centerline (for center line, put offset = 0)
Type 4: Mitre Cut
Type 5: Holes (see next page)
CUT TYPES 1 to 4: