BUG-O Systems SE-4PTD - Manual (Page 11)

11
CUTTING HOLES: TYPE 5
Select Type 5 to cut a hole on the side of a pipe. Using Type 5, the machine is programmed to cut
holes in pipes for branching joints, either square (T-joints) or angled (laterals). The joint must be on
centerline.
The display will ask for small diameter, and then large diameter. Enter the diameter of the branch pipe
for small diameter, and then large diameter, as shown in the diagram, and the diameter of the pipe
being cut for large diameter. Next the display will prompt for angle. Enter the angle, in degrees x 100
(e.g. for 60° enter 6000). For square cuts you must enter 9000 (for 90°).
NOTE:
The type 5 Cut is provided on both the standard SE-4PTD and the Dual program SE-4PTD machines.