Bronkhorst CEM W-300B - Manual (Page 4)

BRONKHORST HIGH-TECH B.V.
Safety Precautions
The following safety precautions should be observed before
using this product and any associated instrumentation.
Although some instruments and accessories would normally
be used with non-hazardous voltages, there are situations
where hazardous conditions may be present.
This product is intended for use by qualified personnel who
recognize shock hazards and are familiar with the safety
precautions required to avoid possible injury. Read the
operating information carefully before using the product.
Before operating an instrument, make sure the line cord is
connected to a properly grounded power receptacle. Inspect
the connecting cables, test leads, and jumpers for possible
wear, cracks, or breaks before each use.
The instrument and accessories must be used in
accordance with its specifications and operating instructions
or the safety of the equipment may be impaired.
When fuses are used in a product, replace with same type
and rating for continued protection against fire hazard.
Opening of the equipment is not allowed. There are no
repairable parts inside. In case of a defect please return the
equipment to Bronkhorst High-Tech.
The symbol on an instrument indicates that the user
should refer to the operating instructions located in the
manual.
Surfaces near the symbol may be hot.
To maintain protection from electric shock and fire,
replacement components in mains circuits, must be
purchased from Bronkhorst®. Standard fuses, with
applicable national safety approvals, may be used if the
rating and type are the same. Other components that are
not safety related may be purchased from other suppliers as
long as they are equivalent to the original component. (Note
that selected parts should be purchased only through
Bronkhorst® to maintain accuracy and functionality of the
product.) If you are unsure about the applicability of a
replacement component, call a Bronkhorst® office for
information.
page 4 9.17.082