Broadata Communications LBC-H/V-T-WP - Manual (Page 7)

LBC-H/V-T-WP User’s Manual
Link Bridge
TM HDMI/VGA Wall Plate Transmitter System
Broadata Technical Support, (800) 214-0222 8
3.0 SETUP
The BCI LBC HDBaseT Extender Series units are used in pairs. One
LBC-H/V-T-WP transmitter unit is located at the near-end (source) and
connected through a single category cable, to one of the LBC or LBH
receivers like the LBC-HDBT-R receiver shown below and located at
the far-end (sink) of the link. Figure 3-1 depicts a typical installation for
the LBC-H/V-T-WP and LBC-HDBT-R.
3.1 Mounting
Before installing the units into your housing, make sure there is
enough space to pull and connect both the electrical and category
cables without stressing them beyond the manufacturer’s
limitations (also known as the minimum bend radius).
3.2 Cabling and Connectors
In order to setup the LBC-H/V-T-WP properly, make sure to
observe the following instructions when installing the proper
cables. The LBC-H/V-T-WP requires two parts to the cabling
setup, the video signal and the transmission connections.
Figure 3-1
LBC-H/V-T-WP with LBC-HDBT-R Transmission Pair