Broadata Communications LBC-H/V-T-WP User Manual
Page 12

LBC-H/V-T-WP User’s Manual
Link Bridge
TM
HDMI/VGA Wall Plate Transmitter System
Broadata Technical Support, [email protected]
13
Note: Refer to Table 1 on page 17 for the RS-232 command
protocol.
3.7
CAT-5e/6 Transmission Connection
Select an appropriate terminated shielded CAT 5e/6 cable. Each
unit’s RJ45 ports in the system are specified for use with RJ45
connectors. Follow the ensuing instructions on installing and
connecting the HDBaseT links:
1.
Ensure the power is off before proceeding with the CAT5e/6
cable installation.
2.
Connect the cable from one unit to the other connecting the
near end LBC-H/V-T-WP unit’s RJ45 port and to the far end
of the LBH-HDMI-AD-R (use any compatible LBC or LBH
series receiver) unit’s RJ45 RX port as illustrated in
Figure 2-7.
Figure 3-6
RS-232 Terminal Block Pin OUT
Figure 3-7
CAT-5e/6 Connection