Broadata Communications LBO-DVI-AD - Manual (Page 9)

LBO-DVI-AD User’s Manual
Link Bridge
TM Fiber Optic DVI Video ConvertingTransmitter System
Broadata Technical Support, (800) 214-0222 10
2.2.1.2 Audio Interface
The audio interface supports two channel high fidelity
transmissions. Two separate mono channels or one stereo
channel is transmitted in each direction. Line-level audio signals
are connected to the LBO-DVI-AD units. The following steps
illustrate the installation procedures for audio devices.
To send audio signals, label and connect one stereo audio-jack
cable to the “AUDIO OUTPUT” connector of the line level audio
source. On the LBO-DVI-AD unit, connect the other end of the
cables to the front panel stereo jack connector labeled “AUDIO
IN” (see Figure 2-3a).
To receive audio signals, at the far-end location, label and
connect one stereo audio-jack cable to the “AUDIO INPUT”
connector of the line level audio receiver. On the
LBO-DVI-AD unit, connect the other end of the cables to the
front panel stereo jack connector labeled “AUDIO OUT” (see
Figure 2-3b).
Figure 2-3a
Audio input to LBO-DVI-AD unit
Figure 2-3b
Audio output to LBO-DVI-AD unit
User’s
Audio Output
User’s
Audio Input