Broadata Communications LBO-DVI-AD User Manual
Page 16
LBO-DVI-AD User’s Manual
Link Bridge
TM
Fiber Optic DVI Video Converting Transmitter System
Broadata Technical Support, [email protected]
17
Note 1: During installation, the installer may need to connect the power
supply output to an appropriate Listed NEC type cable before it
is routed behind a wall. Simply routing the power supply output
cable behind a wall will most likely not comply with applicable
installation requirements. Unit should only be powered by a
power source that is Listed (NEC) Class 2 or a Listed ITE Power
Supply marked/rated as LPS or Limited Power Source.
Note 2: The installation shall be in accordance with the applicable
provisions of the National Electrical Code ANSI/NFPA 70,
Article 725 and the Canadian Electrical Code, Part 1,
Section 16.
Note 3: The power supply shall not be permanently fixed to the building
structure or similar structures.
Note 4: The power supply shall not be located within environmental air
handling spaces or within the wall cavity.
Note 5: The power supply is to be located within the same vicinity as
the A/V processing equipment in an ordinary location, Pollution
Degree 2, secured to the equipment rack within the dedicated
closet, podium or desk.