Broadata Communications LBO-DVI-AD - Manual (Page 7)

LBO-DVI-AD User’s Manual
Link Bridge
TM Fiber Optic DVI Video ConvertingTransmitter System
Broadata Technical Support, (800) 214-0222 8
2.0 SETUP
LBO-DVI-AD-T (or LBO-DVI-AD-R) is a transmitter or receiver and they
can be paired with any DVI/HDMI centric LBO receiver (such as
LBO-DVI-R). One LBO-DVI-AD-T transmitter unit is located at the near-
end and connected through one optical fiber, to the LBO-DVI-AD-R
receiver located at the far-end of the link. Figure 2-1 depicts a typical
installation for the LBO-DVI-AD-T/R.
Figure 2-1
Mini-DVI-AD-T/R Setup
2.1 Mounting
Before installing the units into your housing, make sure there is
enough space to pull and connect both the electrical and optical
cables without stressing them beyond the manufacturer’s
limitations (also known as the minimum bend radius).
2.2 Cabling and Connectors
In order to setup the LBO-DVI-AD-T/R properly, make sure to
observe the following instructions when installing the proper
cables. The LBO-DVI-AD-T/R requires two parts to the cabling
setup, the electrical and the optical.