BrightSign HD600 Hardware Guide - Manual (Page 8)

BrightSign HD600
This information applies to a product under development. Its characteristics and specifications are subject to change without notice. Roku assumes no
obligation regarding future manufacturing unless otherwise agreed to in writing.
www.rokulabs.com © Roku 2006
3 RX+ 4 RC to ground
5 RC to ground 6 RX
7 RC to ground 8 RC to ground
USB
The HD600 has two high speed (400 mbit) USB host ports. The ports have the following pinout:
pin Description pin Description
1 VBUS 2 D-
3 D+ 4 Ground
DB15 VGA connector
The VGA connector is a able to output 1280 X 720 and 1024 X 768 computer RGB video. The connector
has the following pinout (NOTE: This pinout is only accurate for REVC and later. REVB has a hardware
bug on the pinout):
pin Description pin Description
1 RED analog video output 2 GREEN analog video output
3 BLUE analog video output 4 NC
5 Digital ground 6 Analog ground
7 Analog ground 8 Analog ground
9 NC 10 Digital ground
11 NC 12 NC
13 HSYNC output 14 VSYNC output
15 NC
Triple RCA Component HD video connector
The component triple RCA connector is a able to output the following formats:
• Composite video – from Blue jack.
• S-Video: Luma from Green jack and Chroma from Red jack
• 480P video: Y from Green jack, Pr from Red jack, and Pb from Blue jack.
• 720P video: Y from Green jack, Pr from Red jack, and Pb from Blue jack.
• 1080i video: Y from Green jack, Pr from Red jack, and Pb from Blue jack.
To use the S-Video mode, you can use an adaptor that is wired as in this diagram: