Boyertown Solaia CSL6230 - CSL12590 Cast Iron Boiler - Manual (Page 2)

2
Be Aware of Hazard Definitions
Danger: Denotes presence of a hazard which, if ignored, will result in severe personal
injury, death or property damage
Warning: Denotes presence of a hazard which, if ignored, could result in severe personal
injury, death or substantial property damage.
Caution: Denotes the presence of a hazard which, if ignored, could result in minor personal
injury or property damage
Notice: Intended to bring attention to information, but not related to personal injury or
property damage.
Warning
Warning: This equipment must be installed, adjusted, serviced and started only by a qualified
service agency – an individual or agency, licensed and experienced with all codes and ordinances, and
who is responsible for the installation and adjustment of the equipment. All aspects of the installation
must conform to the authority having jurisdiction, or in the absence of such requirements, to the National
Fuel Gas Code, ANSI Z2231.1/NFPA 54 or to the installation of Oil Burning Equipment, NFPA 31.
Read all instructions before proceeding. Follow all instructions completely. Failure to follow these
instructions could result in equipment malfunction causing severe personal injury, death or substantial
property damage.
Do not alter this boiler in any way. The manufacturer will not be liable for any damage resulting from
changes made in the field to the boiler or its components or from improper installation. Failure to comply
could result in severe personal injury, death, or substantial property damage.
Your oil fired boiler is designed to burn natural gas, LP gas, No. 1 or No. 2 heating oil only. Never use
gasoline or a mixture of gasoline and oil.
Do not store gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
The area around the boiler should be kept free and clear of combustible materials.
Never burn garbage or refuse in your boiler.
Never try to ignite oil by tossing burning papers or other material into your boiler.
Do not attempt to start the burner when excess oil vapors or gas has accumulated in the boiler.
D o not operate boiler if the heat exchanger is damaged.
Do not jumper, attempt to bypass, or override any of the safety limit controls.
Do not use this boiler if any part has been under water. Immediately call a qualified service technician to
inspect the boiler and replace any part of the boiler, control system or burner that has been under water.
All installations must conform to the requirements of the authority having jurisdiction. Such applicable
requirements take precedence over the general instructions of this manual.
Where required by the authority having jurisdiction, the installation must conform to the American
Society of Mechanical Engineers Safety Code for Controls and Safety Devices for Automatically Fired
Boilers, ANSI/ASME CSD-1.