Bladez Fitness R400 Recumbent Bike - Manual (Page 30)

30
OPERATION GUIDE:
1. SLEEP MODE:
The computer will enter the sleep mode when there is no signal input and no keys are pressed
after 4 minutes. You can press any key to wake up the computer.
Error Message:
2. ERRORS
a. E1 (ERROR 1):
Normal state: During workout, when the monitor did not receive a signal from the gear
motor for more than 4 seconds and checks 3 successive times then the LCD will show E1.
Power on state: The gear motor will return to zero automatically, when the signal to the
motor cannot be detected for more than 4 seconds then the gear motor’s driver will be cut
off immediately and show the E1 on the LCD display. All the other functions are blank, and
the output signals are cut off.
b. E2 (ERROR 2):
When the monitor read the memory data, if the I.D. code is not correct or the memory IC is
damaged then the monitor will show E2 immediately at power on.
c. E3 (ERROR 3):
After 4 seconds in start mode, the computer detects the motor did not leave the zero point
then the LCD bar displays “E3”.