Dynex DX-LCD32-09 - Manual (Page 20)

20 Specifications
General
Specifications
Product design and specifications are subject to change without notice.
Legal notices
FCC Part 15
This equipment has been tested and found to comply within the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced technician for help.
FCC warning
Changes or modifications not expressly approved by the party
responsible for compliance with the FCC Rules could void the user’s
authority to operate this equipment.
FCC warning
This is a CLASS B product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures to counter interference.
Notices
Specifications and features are subject to change without notice or
obligation.
For service and support call (800) 305-2204.
Problem Solution
One or more channels
cannot be displayed. • Make sure that your TV has
memorized channels.
• Make sure that the channel has
not been deleted from the
memorized channel list. If the
channel was deleted, you can
press the number buttons on the
remote control to tune to the
channel.
• Make sure that the channel is not
blocked through the parental
controls.
Password lost. • If you have forgotten the
password, enter 1397 to open the
Lock menu and set a new
password.
Some menu options cannot
be accessed. • If an option is grayed, the option
is not available for the current
video input mode.
TV cabinet creaks or makes
noises. • This is not a malfunction. When
you use your TV, the temperature
inside the cabinet increases. This
causes the cabinet to expand or
contract, which makes a creaking
noise.
Control buttons on the TV
do not work. • Unplug the power cord, wait a
few seconds, plug the cord back
in again, then turn on your TV.
Type LCD TV
Panel 32" TFT LCD
TV system NTSC-M, ATSC
Receiving channels VHF: 2-13
UHF: 14-69
CATV: 1-125
CADTV: 1-135
DTV: 2-69
Audio multiplex BTSC system
Audio out 6 W × 2
Power requirement AC 120 V, 60 Hz
Power consumption 150 W
Dimensions
(W × H × D) 31.9 Ч 23 Ч 10 inches
(81.1 Ч 58.3 Ч 25.5 cm)
Weight 30.9 lbs (14 kg)
Temperature Storage: 32° to 122°F (0° to 50°C)
Working: 41° to 104°F (5° to 40°C)
Input ports Composite video/audio (L/R) (1)
S-Video (1)
Component video/audio (L/R) (2)
HDMI (2)
VGA/audio (1)
Antenna (1)
Output ports Composite video/audio (L/R) (1)
Headphone (1)
S/PDIF (optical) (1)
Control port RS-232