Dolby Laboratories VCZ625 - Manual (Page 7)

VCZ625
13
8. OPERATION
Basic Operations
■ Using the unit separately
Confirm that the CeNET/STANDALONE select
switch on the backside of the unit is set to the
STANDALONE side.
Confirm that the CeNET/STANDALONE select
switch on the remote control unit is set to the
STANDALONE side.
Turning on the power
Note:
• To prevent the car battery from running out,
perform operations on the unit with the car engine
running.
Press the [POWER] buttons on the remote control
receiver.
When the message “NO MAGAZINE” is displayed
in the screen, load a magazine into the main unit.
After disc checking operation, playback of the disc
starts.
When the message “NO DISC” is displayed in
the screen, remove the magazine and load a disc
into the magazine.
This may take time as the unit performs detailed
disc checking to light on the disc indicator.
● To turn off the power
Press the [POWER] button.
The unit is turned off and the indicator on the
receiver for remote control unit goes off.
Selecting a disc
Press the [DISC SEL] button on the remote
control unit.
Press the numeric button for the disc number
(1 to 6) that you want to select.
When a disc is switched to some other disc, the
newly-selected disc plays automatically.
If you want to return to the original mode, press
the [DISC SEL] button again.
Adjusting the volume
WARNING
DVD-Videos may be played back with
particularly loud sound. Increase the volume
gradually from the minimum after the video
images are displayed.
Press the [VOLUME] button on the remote control
unit.
[ ] : Increases the volume.
[ ] : Decreases the volume.
Turning off the sound (mute)
Press the [MUTE] button on the remote control
unit.
The monitor displays “MUTE”.
● To restore the volume
Press the [MUTE] button again.