Besafe X3-GB - Manual (Page 9)

16 17
Positioning of the child
Position of the shoulder straps:
Check that the shoulder strap
slots are levelled with your child’s
shoulders (27).
too high
too low
correct
Pull the shoulder straps up
while pressing the button of
the central adjuster (29).
Open the harness buckle.
1-
3-
4-
(27)
(28)
(29)
Put the shoulder belt through the
belt clamps. Make sure the belt is
not twisted (25).
Adjust the belt guiding hook outwards
with the ratchet (26). Continue
tightening until the seat is pressed
well into the back rest of the car seat.
Push the head rest in the correct
position (refer to ‘Positioning of the
child’ on page 17). The seat is now
ready to use.
If the seat is installed in the back seat of the vehicle, push the
front seat of the vehicle forward as much as possible.
Loosen the tension in the car belt by moving the belt guiding
hook inwards with the ratchet, not further than the stop sign.
Unlock the belt clamps and unlock the car belt.
Remove the car belt and remove the seat from the vehicle.
Removing the seat
8-
9-
10-
11-
2-
1-
3-
4-
(25)
(26)
The height of the shoulder
straps and the head rest can be
adjusted by releasing the release
handle at the back of the head
rest and pulling the head rest up
or down while keeping the head
rest upright (28).
2-
Push the seat firmly into the
car seat.
Tight installation is most important
for forward facing seats.
Tension the belts as follows:
Pull the shoulder belt upwards (A).
Have a firm grip on the shoulder
belt in the seat area (B). Close the
clamp on the inner side (C).
Pull upper belt part on the door
side and close clamp D (25).
A
C
D
B