Besafe X3-GB - Manual (Page 8)

14 15
Move the front brace outwards with the ratchet. Continue
tightening until the brace is pressed well into the back rest of
the vehicle seat (19).
Connect the anchor belts with the child seat. The anchor
belts must be crossed over.
Forward-facing belt installation
It is NOT ALLOWED to mount the seat in a front
passenger seat WITH AN ACTIVATED AIRBAG.
When mounting in the back seat of the vehicle,
push the front seat of the vehicle forward as much
as possible.
When mounting in the front seat of the vehicle, adjust the back
rest in an upright position.
Remove the floor support and the
front brace from the seat.
Put the child seat on the seat of the
vehicle. Unlock the belt clamps (22).
Pull the hip belt around the bottom
base of the seat and click the car
belt in the buckle (24).
Position the hip belt over the belt
guiding hook (24).
!
17-
18-
19-
1-
2-
3-
4-
5-
6-
7-
(22)
(24)
20-
(21) (20)
Tighten the anchor belts to their maximum (20).
Lock the floor support with the locking bolt (21).
(19)
If the seat is installed in the back seat of the vehicle, push the
front seat of the vehicle forward as much as possible.
Remove the locking bolt from the floor support, adjust the
floor support in the highest position and lock again with the
locking bolt.
Release the anchor belts.
Move the front brace inwards with the ratchet, not further than
the stop sign.
Remove the car belt from the front brace and the seat base.
Pull the seat back towards the front. Turn the seat so you can
easily remove the seat.
Remove the anchor belts from the vehicle.
Removing the seat
1-
3-
4-
2-
5-
6-
7-
(23)
Release the release handle at the
back of the head rest and push the
head rest down while keeping the
head rest upright (23).
click!