Besafe X3-GB - Manual (Page 4)

6 7
The floor support must go through the belt loop. The belt loop
must also be led into the hook on the floor support (2).
Do not fasten the locking bolt yet.
4-
5-
(2)
Before you can install the seat in the vehicle, you have to
mount 2 anchor belts which will be connected with the
connectors at the backside of the child seat. The anchor
belts have to be connected with the vehicle.
This can be done in 4 different ways.
Release the fixing bolts on the 2 rear/front
fixing points of the rails of the front seat of
the vehicle.
The attachment fittings have to go
underneath the rail on the vehicle seat
chassis. Reassemble the fixing bolts
and tighten firmly (3).
Thread the belt loop of the anchor belt
through the opening of the attachment
fitting. Then bring the anchor belt
locking device through the belt loop
and pull hard (4).
Secure an anchor belt round each
of the rails of the front seat of the
vehicle by bringing the locking
device of the anchor belt through the
belt loop. Pull tight (5).
Cross the anchor belts under the front
seat of the vehicle.
First alternative: using the rails
of the front seat
Second alternative: using the rails
of the front seat
Third alternative: using the front seat
Insert the belt loop through the gap between the seat cushion
and the seat back on the front seat of the vehicle. Then bring
the locking device through the belt loop and tighten (6).
Cross the anchor belts under the front seat of the vehicle (6).
6-
a-
a-
a-
b-
b-
b-
c-
(3)
(4)
(5)
(6)