Belshaw Adamatic HG18C Glazer - Manual (Page 8)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
2 MN-1752EN HG / HGEZ Standard & Under Counter OM
2 Cleaning
Cleaning the glazer
For your safety, observe the following warnings
throughout the entire cleaning process.
WARNING
Thoroughly clean and dry the floor if
glaze, water, or other materials are spilled.
Materials spilled on the floor can cause
serious injury or loss of life.
Once a day, clean as explained below:
1. Lift the screen support rod assembly out of
the kettle and wash with mild soap and hot
water.
2. HGEZ only: Remove applicator track frame
from the kettle and wash with mild soap and
water.
3. Lift the kettle and drip tray off the frame and
wash both with mild soap and hot water.
CAUTION
To prevent damage to the kettle, never use
a metal object to scrape the kettle use
only a plastic or rubber bowl scraper.
4. Wash the glaze applicator using the
instructions below.
5. Replace the kettle into the frame. Reinstall
the applicator track frame. Replace the
screen assembly support rods, and the
applicator. Close the drain valve.
Cleaning the glaze
applicator
HGEZ
To clean the applicator, the gate must be
removed.
1. Lift the gate up and rotate it out. It may help
to push on the gate tabs from the outside of
the applicator while rotating the gate.
2. Remove the clamping knob so the rollers and
shaft can be removed for cleaning. See
Figure 3-1.
3. Clean the parts with mild soap and hot water
and dry thoroughly.
4. Reassemble the glaze applicator using the
instructions found in Section 1, Glaze
applicator assembly.
HG
1. Clean the scoop with mild soap and hot water
and dry thoroughly.