Belshaw Adamatic FT42 Feed Table - Manual (Page 7)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Feed Table FT42 OM MN-1667EN 1
1 Operation
Operation
CAUTION
To avoid damaging the machine, never use
force to assemble or operate the Feed
Table.
1. Test to make sure that the automatic timing
for the Feed Table is working. To do this:
a. Turn on the Donut Robot’s conveyor
drive.
b. Turn on the Feed Table’s conveyor
drive.
The Feed Table should receive a signal
from the Donut Robot, move forward the
distance needed to supply one pocket of
donuts, and then stop until it receives the
next signal.
2. Proof your donuts on the proofing cloths
from the Feed Table.
3. Put a proofing board, with a proofing cloth
on it, on the Feed Table.
4. Press the prime switch on the power head
assembly. The hooks on the Feed Table will
grab the proofing cloth off of the proofing
board. Allow the cloth to advance to the
front of the Feed Table.
5. Release the prime switch and turn on the
main power. Remove the proofing board.
When the Feed Table is on, the Feed Table
automatically advances donuts when the
Donut Robot is ready to accept them. After
the donuts go into the fryer, the proofing
cloths are carried underneath the Feed Table
and fall onto the work surface.
6. Continue putting proofing cloths on the Feed
Table.