Belshaw Adamatic FT42 Feed Table - Manual (Page 16)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
2 MN-1668EN Feed table FT42 TS
2 Maintenance
If you ever need to adjust the tension of the
conveyor chains, follow these steps:
1. Loosen the hex head bolts that hold the
roller shaft at the outfeed end of the
conveyor.
2. Pull the shaft until the chains reach the
correct tension. The tension is correct when
you can lift the chains about 1”/2.5 cm
above the surface of the Feed Table. Each
chain should have the same tension.
3. Tighten the hex head bolts that hold the
roller shaft.