Belshaw Adamatic FT42 Feed Table - Manual (Page 18)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
4 MN-1668EN Feed table FT42 TS
THE CONVEYOR CHAINS DO NOT ADVANCE WHEN THE MAIN POWER IS
ON OR WHEN THE PRIME SWITCH IS PRESSED, AND THE PILOT LIGHT
DOES NOT COME ON.
Possible Causes What To Do
The power cord is not connected. Plug in the power cord.
The circuit breaker for the gear box outlet on the
Donut Robot’s heater head is tripped. Push the white reset button near the outlet.
WARNING
To avoid electric shock or other injury, before
doing any of the following, unplug the machine.
The black or white wire in the power cord is
broken or poorly connected. Repair the cord and/or make the proper connection.
The fuse on the Feed Table is blown. Replace the fuse.
The fuse for the Donut Robot’s conveyor is
blown. Replace the fuse.