Beisler 100-58 - Manual (Page 37)

2-17
35 Thread cutter position [45] (01 - 59)
start correction threat cutter impulse; the smaller the number, the
earlier the bobbin threat cutter is started
36 Threat cutter duration [0,1 Sek.]
duration of bobbin threat cutter should be minimized, otherwise the
main clamp is already driving
37 Piping turn delay [00 mm]
37: after the mitre cutting, the main clamp drives the distance set here
in mm.
38 Piping turn duration [0,0 Sek.]
05: impulse duration for the piping turn