BECKHOFF Onboard SATA RAID User Manual
Page 9
Status information
Display after the replacement of a defective hard disk
Without rebuilding the RAID
volume
If the defective hard disk was exchanged (please refer to chapter
Requirements for a replacement hard disk
) whilst the Industrial PC was
switched off, or if the hard disk was exchanged under Windows during
operation without starting a rebuild of the RAID volume, the second boot
screen will appear as follows at the next PC start-up:
Boot screen
A hard disk is shown on Port 1 that does not belong to any RAID volume.
The new hard disk can be selected in the Configuration Utility for the
rebuild of the RAID volume (see chapter
Selecting a hard disk for the RAID
However, it is also possible, without first opening the Configuration Utility,
to boot Windows, where the hard disk can then also be selected for the
rebuild of the RAID volume (see chapter
Selecting a hard disk (drive) for
Beckhoff onboard SATA-RAID
7