BECKHOFF EP1908 - Manual (Page 32)

Operation
30 EP1908-0002
Safe parameters overview
Parameter name Meaning Values
FSoE_Address Address of the rotary switch or the setting
in the EP1908 1 to 4095
Operating Mode Digital Digital
Sensor test channel 1
active The clock signal of channel 1 (pin 1) is
checked at the channel 1 input (pin 2). TRUE / FALSE
Sensor test channel 2
active The clock signal of channel 2 (pin 3) is
checked at the channel 2 input (pin 4). TRUE / FALSE
Sensor test channel 3
active The clock signal of channel 3 (pin 3) is
checked at the channel 1 input (pin 2). TRUE / FALSE
Sensor test channel 4
active The clock signal of channel 4 (pin 3) is
checked at the channel 4 input (pin 4). TRUE / FALSE
Sensor test channel 5
active The clock signal of channel 5 (pin 5) is
checked at the channel 1 input (pin 2). TRUE / FALSE
Sensor test channel 6
active The clock signal of channel 6 (pin 3) is
checked at the channel 6 input (pin 4). TRUE / FALSE
Sensor test channel 7
active The clock signal of channel 7 (pin 7) is
checked at the channel 1 input (pin 2). TRUE / FALSE
Sensor test channel 8
active The clock signal of channel 8 (pin 3) is
checked at the channel 8 input (pin 4). TRUE / FALSE
Logic channel 1 and 2 Logic of channels 1 and 2 see operating modes table
Logic channel 3 and 4 Logic of channels 3 and 4 see operating modes table
Logic channel 5 and 6 Logic of channels 5 and 6 see operating modes table
Logic channel 7 and 8 Logic of channels 7 and 8 see operating modes table
Velocity limit channel 1 Upper frequency limit for channel 1 Frequency in 1/10 Hz
Velocity limit channel 2 Upper frequency limit for channel 2 Frequency in 1/10 Hz
Velocity limit channel 3 Upper frequency limit for channel 3 Frequency in 1/10 Hz
Velocity limit channel 4 Upper frequency limit for channel 4 Frequency in 1/10 Hz
Velocity limit channel 5 Upper frequency limit for channel 5 Frequency in 1/10 Hz
Velocity limit channel 6 Upper frequency limit for channel 6 Frequency in 1/10 Hz
Velocity limit channel 7 Upper frequency limit for channel 7 Frequency in 1/10 Hz
Velocity limit channel 8 Upper frequency limit for channel 8 Frequency in 1/10 Hz
Store Code This parameter is required for the
TwinSAFE Restore Mode 0x0000
Project CRC This parameter is required for the
TwinSAFE Restore Mode 0x0000
Identity internal use (read only)
Detected Modules internal use (read only)