BECKHOFF KL1904 - Manual (Page 28)

Operation
26 KL1904
4.2.5 Entering a TwinSAFE address and parameters in the System Manager
The TwinSAFE address set at the DIP switch must also be entered under the Parameters tab
(S_Address entry).
Parameter overview
PrmName Meaning Values
S_Address DIP switch address 1 to 1023
Channel 1 Activation of channel 1 active/not active
Channel 2 Activation of channel 2 active/not active
Channel 3 Activation of channel 3 active/not active
Channel 4 Activation of channel 4 active/not active
Sensor test channel
1 The clock signal for connection Input1+ is
checked at connection Input1-. active/not active
Sensor test channel
2 The clock signal for connection Input2+ is
checked at connection Input2-. active/not active
Sensor test channel
3 The clock signal for connection Input3+ is
checked at connection Input3-. active/not active
Sensor test channel
4 The clock signal for connection Input4+ is
checked at connection Input4-. active/not active
Channel 1 and 2 For two-channel evaluation, inputs 1 and 2 must
have the same signal states. single-channel evaluation /
two-channel evaluation
Channel 3 and 4 For two-channel evaluation, inputs 3 and 4 must
have the same signal states. single-channel evaluation /
two-channel evaluation
Ambivalence
channel 1 and 2 If active, inputs 1 and 2 must have different signal
states. not active/active
Ambivalence
channel 3 and 4 If active, inputs 3 and 4 must have different signal
states. not active/active