BECKHOFF C5002 - Manual (Page 7)

INDUSTRIE ELEKTRONIK Eiserstraße 5 / D-33415 Verl / Phone 05246/963-0 / Fax 05246/963-149
6 Operating Instructions Slide-in PC C5002
C5002
Setting the mains voltage Mains voltages of 230 V 50 Hz or 115 V 60 Hz may be set. In order to do
this the slide switch (see photos below) is moved to the appropriate
position with the aid of a small screwdriver. The voltage that has been set
can be read.
Changing from 230 V to
115 V Changing from 115 V to
230 V
Serial interfaces
RS 232
COM1 - COM2 The basic version of the C5002 Industrial PC has two serial interfaces,
COM1 and COM2, using the type RS 232, which are brought to a 9 pin
SUB-D pin connector.
Parallel interface
Printer
LPT1 The parallel interface corresponds to the Centronics standard, and is
addressed by the software as LPT1.
PS/2 Connections
PS/2 The upper PS/2 connector allows a PS/2 mouse to be used, while a PC
keyboard can be connected to the lower PS/2 connector.
USB Interfaces
USB1 – USB2 Both USB interfaces provide for the connection of any peripheral devices
with USB connections.
Video connection
Video A 15-pin SUB-D socket allows a VGA monitor to be
connected.
Additional plug-in cards (optional)
Type plate There is a type plate on the rear of the PC which provides information
about the hardware configuration of the PC at the time it was supplied.