BECKHOFF C5002 - Manual (Page 10)

INDUSTRIE ELEKTRONIK Eiserstraße 5 / D-33415 Verl / Phone 05246/963-0 / Fax 05246/963-149
Operating Instructions Slide-in PC C5002 9
C5002
Disposal
Remove the Industrial PC
and dismantle it Observe
national electronics scrap
regulations In order to dispose of the device, it must be removed and fully dismantled.
The housing can be sent for metal recycling. Electronic parts such as disk
drives and circuit boards must be disposed of in accordance with national
electronics scrap regulations.
Faults
Quote the project number If servicing is required, please quote the project number of your PC.
fault Cause Procedure
No function after the Industrial PC
has been switched on No power supply. 1. Measure voltage at
connection, check plug
wiring.
2. Call Beckhoff Service.
The Industrial PC does not boot
fully Floppy disk in drive.
Hard disk damaged (e.g. by
switching off while software
running).
Incorrect setup.
Other cause.
Remove floppy disk and
press any key
Call Beckhoff Service.
Check the set-up. If
necessary, call the Beckhoff
service department
Call Beckhoff Service.
Computer boots, software starts,
but control does not operate
correctly Cause of the fault is either in the
software or in parts of the plant
outside the Industrial PC. Call the manufacturer of the
machine or the software.
Error during floppy disk access Faulty floppy disk.
Faulty disk drive.
Check disk in another PC.
Call Beckhoff Service.