The user’s duties, Appropriate use – BECKHOFF C5002 User Manual
Page 5
INDUSTRIE ELEKTRONIK
Eiserstraße 5 / D-33415 Verl / Phone 05246/963-0 / Fax 05246/963-149
4
Operating Instructions
Slide-in PC C5002
C5002
Procedure in the event of a
fault
In the event of a fault in the Industrial PC, appropriate measures can be
determined with the aid of the list in the “Faults” section.
The BECKHOFF Service number:
for Germany: 05246/963-460
international: 0049-5246/963-460
The user’s duties
Read the operating
instructions
Every user of the Industrial PC must have read these operating
instructions.
Software knowledge
Every user must be familiar with any of the functions of the software
installed on the PC that he can reach.
Appropriate Use
The C5002 Industrial Computer is intended for fitting into 19 inch racks for
industrial application in machine and plant control engineering. A complete
IBM compatible PC with a standard ATX motherboard, hard disk and floppy
drive is built into a 7-slot plug-in unit.
Do not use the PC in areas
of explosive hazard
The Industrial PC may not be used in areas of explosive hazard.
The following technical data must be observed during operation:
Environmental conditions
Ambient temperature:
0 to 55 °C
Atmospheric humidity:
Maximum 95 %, non-condensing
Shock resistance
Housing & chassis:
Vibrations 5 G at 10..55 Hz
Impact resistance 30 G
Disk drive:
Vibrations 0.5 G at 5..500 Hz
Impact resistance 5 G
Hard disk:
Vibrations 0.5 G at 17..500 Hz
Impact resistance 10 G
Protection type:
IP60
Power supply
230/115 V AC mains power
supply unit
Supply voltage:
Switchable between
115 V 60 Hz
230 V 50 Hz
Max. power consumption: 64 W for the basic version
Compatibility
Resistance to interference: according to EN 50082-2
Transport and storage
The same values for atmospheric humidity and shock resistance are to be
observed during transport and storage as in operation. The shock
resistance during transport can be improved by means of suitably packing
the Industrial PC. The ambient temperature during storage and transport
must be between –20 °C and +60 °C.