Attach cover – BECKHOFF CX1000 User Manual

Page 38

Text mode
Original mode

Fitting and wiring

Embedded PC

FIG. 4: Tension straps back in starting position

3. Attach Cover

If the connection area does not have a closing cover on the left-hand side, the cover that was previously removed
should be pressed over the connections until it audibly engages.

Note:
If the CX1000/CX1020 configuration is not positioned on the top-hat rail it is possible to join the connection first with
the CX1000/CX1020 configuration, as shown in FIG. 3, and then to clip the entire module onto the top-hat rail.

Note:
A locking mechanism prevents the individual housings from being pulled off again.

This manual is related to the following products:

CX1020