Baumatic BHI909TS.GWK - Manual (Page 41)

41
My appliance isn’t working correctly
Problem Possible Causes Solution
The induction hob cannot be
turned on. No power to the
appliance.
o
Make sure the hob is
connected to the power
supply correctly and that
it is switched on.
o
Check whether there is a
power cut in your home
or area.
The touch controls are
unresponsive. The safety lock is
activated.
o
Unlock the controls by
following the instructions
in this manual.
The touch controls are difficult
to operate. There may be a slight
film of water over the
controls.
You may be using the tip
of your finger when
touching the controls.
o
Make sure the control
panel is clean and dry.
o Use the ball of your finger
when touching the
controls.
The glass is being scratched. Pans with rough edges
are being used.
An unsuitable cleaning
product or scourer is
being used.
o
Only use pans with flat
and smooth bases.
o
Use appropriate cleaning
products and the
induction hob scraper for
cleaning.
Some pans make crackling or
clicking noises.
This may be caused by
the construction of your
pans where layers of
different metals vibrate
differently.
o
This is normal for pans
and does not indicate a
fault.
The induction hob makes a
low humming noise when
used on a high power level.
This is caused by the
technology of induction
cooking.
o
This is normal but the
noise should lessen or
disappear when you
decrease the power level.
There is a fan noise coming
from the induction hob. A cooling fan that is built
into your induction hob
has come on to prevent
the electronics from
overheating. It may
continue to run even
after you have turned the
hob off.
o
This is normal and
requires no action. Do not
switch the power to the
hob off at the supply
while the fan is running.
Pans do not become hot and a
“U” symbol appears in the
display.
The induction hob cannot
detect the pan because it
is not suitable for
induction cooking.
The induction hob cannot
detect the pan because it
is too small for the
cooking zone or not
properly centred on it.
o
Use pans that are suitable
for induction cooking.
o
Centre the pan and make
sure that its base
matches the size of the
cooking zone.
The induction hob or a
cooking zone has turned itself
off unexpectedly. A tone
sounds and an error code is
displayed (possibly alternating
with one or two digits in the
timer display).
Technical fault.
o
Refer to the error codes in
the next section and if the
fault cannot be remedied
call the Customer Care
Department.